1 (edited by mohamed.zaky.anwar 2020-07-06 04:49:35)

Topic: RemotXY programmer is not responding

I am trying to make an application that has 1 joy stick , 2 leds , 1 button and 1 text
However whenever I try to upload  it. it starts normal uploading then on 100% after few minutes it gives me that error
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x1b
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x1b
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x1b
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x1b
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x1b
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x1b
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x1b
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x1b
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x1b
Problem uploading to board.  See http://www.arduino.cc/en/Guide/Troubleshooting#upload for suggestions.
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x1b

I use Arduino Uno , ESP8266 for communication
I make Rx of ESP to Tx to Arduino , Tx of ESP to Rx to Arduino and other connections like this video
https://www.youtube.com/watch?v=2cjufbgOBYo

I need help please because it is urgent

2

Re: RemotXY programmer is not responding

First remove voltage pin of esp module from board then upload program to board then attached voltage pin of esp module

3

Re: RemotXY programmer is not responding

When you load a program into uno you must disconnect the ESP