<![CDATA[RemoteXY community — RemotXY programmer is not responding]]> https://forum.remotexy.com/viewtopic.php?id=1078 Thu, 13 May 2021 08:02:16 +0000 PunBB <![CDATA[Re: RemotXY programmer is not responding]]> https://forum.remotexy.com/viewtopic.php?pid=3924#p3924 When you load a program into uno you must disconnect the ESP

]]> Thu, 13 May 2021 08:02:16 +0000 https://forum.remotexy.com/viewtopic.php?pid=3924#p3924 <![CDATA[Re: RemotXY programmer is not responding]]> https://forum.remotexy.com/viewtopic.php?pid=3921#p3921 First remove voltage pin of esp module from board then upload program to board then attached voltage pin of esp module

]]> Thu, 13 May 2021 03:08:36 +0000 https://forum.remotexy.com/viewtopic.php?pid=3921#p3921 <![CDATA[RemotXY programmer is not responding]]> https://forum.remotexy.com/viewtopic.php?pid=3132#p3132 I am trying to make an application that has 1 joy stick , 2 leds , 1 button and 1 text
However whenever I try to upload  it. it starts normal uploading then on 100% after few minutes it gives me that error
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x1b
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x1b
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x1b
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x1b
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x1b
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x1b
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x1b
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x1b
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x1b
Problem uploading to board.  See http://www.arduino.cc/en/Guide/Troubleshooting#upload for suggestions.
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x1b

I use Arduino Uno , ESP8266 for communication
I make Rx of ESP to Tx to Arduino , Tx of ESP to Rx to Arduino and other connections like this video
https://www.youtube.com/watch?v=2cjufbgOBYo

I need help please because it is urgent

]]> Mon, 06 Jul 2020 04:35:00 +0000 https://forum.remotexy.com/viewtopic.php?pid=3132#p3132