The set up is an ESP01 connected via software serial Ports 7 and 8 after changing the board rate to 19200.

I include a snapshot of the log, which as you can see drops out  after setting up the IP address with connection refused, so it is not running my code.

Also it is not setting up the name of the SSID I selected in the arduino sketch. It shows as ESP name.

I am running it on a Arduino nano.
I have having a problem with a remotexy arduino program I downloaded from your site.

The set up is an ESP01 connected via software serial Ports 7 and 8 after changing the board rate to 19200.

I include a snapshot of the log, which as you can see drops out  after setting up the IP address with connection refused, so it is not running my code.

Also it is not setting up the name of the SSID I selected in the arduino sketch. It shows as ESP name.

I am running it on a Arduino nano.

Unable to upload screenshots here

Stephen Adams