I purchased the annual subscription for remoteXY because I had read that it supported the Arduino Nano 33 BLE board

Hopefully the moderator can provide the step by step instructions describing how to configure the Nano 33 BLE board.

FYI - below are the instructions published (that do not appear on my web page interface) . . . . . . . . .

1. Go to the RemoteXY website (https://remotexy.com/) and create a new project.

2. In the "Select the device type" section, click on the "All devices" dropdown menu.

3. Scroll down until you find the "Arduino" section and click on it.

4. In the "Select the board" section, scroll down until you find the "Arduino Nano 33 BLE" option.

5. Click on the "Select" button next to the "Arduino Nano 33 BLE" option.

6. Choose the desired layout for your GUI and customize it as needed.

7. Click the "Generate source code" button to generate the code for your project.

8. Follow the instructions provided in the code to upload it to your Arduino Nano 33 BLE and connect to the RemoteXY app.