//////////////////////////////////////////////
// RemoteXY include library //
//////////////////////////////////////////////
// you can enable debug logging to Serial at 115200
//#define REMOTEXY__DEBUGLOG
// RemoteXY select connection mode and include library
#define REMOTEXY_MODE__ESP8266WIFI_LIB_POINT
#include <ESP8266WiFi.h>
// RemoteXY connection settings
#define REMOTEXY_WIFI_SSID "RemoteXY"
#define REMOTEXY_WIFI_PASSWORD "12345678"
#define REMOTEXY_SERVER_PORT 6377
#include <RemoteXY.h>
// RemoteXY GUI configuration
#pragma pack(push, 1)
uint8_t RemoteXY_CONF[] = // 72 bytes
{ 255,4,0,0,0,65,0,17,0,0,0,24,1,106,200,2,1,0,3,0,
4,38,114,14,36,16,2,26,3,16,8,24,44,2,2,26,10,71,29,24,
24,52,4,26,31,79,78,0,31,79,70,70,0,1,0,10,42,75,24,24,
48,4,26,31,79,78,0,31,79,70,70,0 };
// this structure defines all the variables and events of your control interface
struct {
// input variables
int8_t slider_01; // from 0 to 100
uint8_t select_01; // =0 if select position A, =1 if position B ...
uint8_t pushSwitch_01; // =1 if state is ON, else =0
uint8_t pushSwitch_02; // =1 if state is ON, else =0
// other variable
uint8_t connect_flag; // =1 if wire connected, else =0
} RemoteXY;
#pragma pack(pop)
/////////////////////////////////////////////
// END RemoteXY include //
/////////////////////////////////////////////
#define PIN_PUSHSWITCH_01 D2
void setup()
{
RemoteXY_Init ();
pinMode (PIN_PUSHSWITCH_01, OUTPUT);
// TODO you setup code
}
void loop()
{
RemoteXY_Handler ();
digitalWrite(PIN_PUSHSWITCH_01, (RemoteXY.pushSwitch_01==0)?LOW:HIGH);
// TODO you loop code
// use the RemoteXY structure for data transfer
// do not call delay(), use instead RemoteXY_delay()
}
]]>