RemoteXY community — Bluetooth connection issue

Re: Bluetooth connection issue

2025-12-11T08:02:19Z

This was fixed in version 1.13.4

Re: Bluetooth connection issue

2025-12-10T14:34:08Z

I am having an issue also when trying to use Bluetooth and RemoteXY on my iPhone. In the past I created a Bluetooth connection to an ESP 32 which worked fine. Now when I try to use it with a newer iPhone, I get the message that you describe.

The iPhone seems to communicate as expected with Wi-Fi where I use a soft Access Point. I haven't worked with this much lately and don't know what has changed concerning the Bluetooth situation.

Bluetooth connection issue

2025-11-15T22:28:07Z

Hello,

I'm wondering if anyone else is having the same (kind of) issue as me. This is not a huge deal because it basically works - but I'm still constantly hitting the same aggravating snag and I would like to eliminate it.

FYI this is regarding app v1.13.3 on iPhone, registered as Pro, connecting to an ESP32 dev board) This issue did not occur at all when I first installed the app. Now it happens every time.

When I launch the app the first connection attempt always fails, with this error message:
"Bluetooth is not enabled. Go to iOS settings and turn on the Bluetooth."

BUT - Bluetooth _IS_ enabled. I can tap OK to dismiss that message and then immediately tap the same interface button and it will launch. After that initial failed connection, it always works perfectly - i can disconnect and re-connect with no issues until the app is shut down. Then after relaunching the app I will get the error again on the first connection attempt. This is perfectly repeatable.

Any thoughts ?