Sorry but this has nothing to do with remotexy. And I see nothing in your code about a servo or a motor... I suggest you ask on the arduino forum.

/*
   -- New project --
   
   This source code of graphical user interface
   has been generated automatically by RemoteXY editor.
   To compile this code using RemoteXY library 2.4.3 or later version
   download by link http://remotexy.com/en/library/
   To connect using RemoteXY mobile app by link http://remotexy.com/en/download/                   
     - for ANDROID 4.5.1 or later version;
     - for iOS 1.4.1 or later version;
   
   This source code is free software; you can redistribute it and/or
   modify it under the terms of the GNU Lesser General Public
   License as published by the Free Software Foundation; either
   version 2.1 of the License, or (at your option) any later version.   
*/

//////////////////////////////////////////////
//        RemoteXY include library          //
//////////////////////////////////////////////

// RemoteXY select connection mode and include library
#define REMOTEXY_MODE__ESP8266_HARDSERIAL_POINT

#include <RemoteXY.h>

// RemoteXY connection settings
#define REMOTEXY_SERIAL Serial
#define REMOTEXY_SERIAL_SPEED 115200
#define REMOTEXY_WIFI_SSID "RemoteXY"
#define REMOTEXY_WIFI_PASSWORD "12345678"
#define REMOTEXY_SERVER_PORT 6377

// RemoteXY configurate 
#pragma pack(push, 1)
uint8_t RemoteXY_CONF[] =
  { 255,2,0,0,0,23,0,10,28,0,
  1,0,37,16,24,24,2,31,88,0,
  1,0,68,32,22,22,2,31,88,0 };
 
// this structure defines all the variables and events of your control interface
struct {

    // input variables
  uint8_t button_1; // =1 if button pressed, else =0
  uint8_t button_2; // =1 if button pressed, else =0

    // other variable
  uint8_t connect_flag;  // =1 if wire connected, else =0

} RemoteXY;
#pragma pack(pop)

/////////////////////////////////////////////
//           END RemoteXY include          //
/////////////////////////////////////////////

#define PIN_BUTTON_1 9
#define PIN_BUTTON_2 8
#define enA 10

void setup()
{
  RemoteXY_Init ();
 
  pinMode (PIN_BUTTON_1, OUTPUT);
  pinMode (PIN_BUTTON_2, OUTPUT);
 
  // TODO you setup code
 
}

void loop()
{
  RemoteXY_Handler ();
 
  analogWrite(enA, 200);
  digitalWrite(PIN_BUTTON_1, (RemoteXY.button_1==0)?LOW:HIGH);
  digitalWrite(PIN_BUTTON_2, (RemoteXY.button_2==0)?LOW:HIGH);
 
  // TODO you loop code
  // use the RemoteXY structure for data transfer
  // do not call delay()

}