1 Topic by revaprerana (edited by revaprerana 2025-04-30 18:18:18)

  • revaprerana
  • New member
  • Offline
  • From: india
  • Registered: 2019-08-18
  • Posts: 5

Topic: led indicator status not updated after reset or reboot

loop  if (RemoteXY.button_21 == 1) {
 
  digitalWrite(PIN_SWITCH_2, LOW); EEPROM.write(90, 0); EEPROM.write(100, 1);EEPROM.commit();
      RemoteXY.led_03 =EEPROM.read(100);
  } 

setup.(){digitalWrite(PIN_SWITCH_2, EEPROM.read(90) ? HIGH : LOW);delay(2000);}

After reset esp8266 node mcu PIN_SWITCH_2 status updated ok. But  RemoteXY.led_03 not updated


......SOLVED OK..MISTAKE IN EEPROM ADDRESS OVERLAPPING

THANKS FOR YOUR IMMEDIATE REPLY..ADMIN

RJC

2 Reply by remotexy

  • remotexy
  • remotexy
  • Administrator
  • Offline
  • Registered: 2016-10-27
  • Posts: 1,202

Re: led indicator status not updated after reset or reboot

try this:

void setup () {
  RemoteXY_Init ();
  RemoteXY.led_03 = EEPROM.read(100); // <----- ADD THIS  LINE
  digitalWrite(PIN_SWITCH_2, EEPROM.read(90) ? HIGH : LOW);
}